The arc suppression switchis used for temporary bypass jumper connections. When connecting, the jumper cable is in a non‑conductive state. After the load break switch is installed, an insulated pull cord extended from the switch is used to remotely close the contacts, allowing current to flow through the jumper cable. This design helps prevent hazards associated with incorrect operation or connecting a bypass jumper set under a fault current condition during installation. Insulated gloves must be worn during installation. The load break switch must be inspected and cleaned after 25 uses or 90 days, whichever comes first.
Contact：+86 186 2706 5035 Mr. Gullian Chen +86 132 6058 4523 Mr. Guihua LiThe arc suppression switchis used for temporary bypass jumper connections. When connecting, the jumper cable is in a non‑conductive state. After the load break switch is installed, an insulated pull cord extended from the switch is used to remotely close the contacts, allowing current to flow through the jumper cable. This design helps prevent hazards associated with incorrect operation or connecting a bypass jumper set under a fault current condition during installation. Insulated gloves must be worn during installation. The load break switch must be inspected and cleaned after 25 uses or 90 days, whichever comes first.
Address：A8 Building, Rongchuang Zhigu Industrial Park, No.555, Wenhua Avenue, Hongshan District, 430072 Wuhan, China
Telphone：+86 186 2706 5035 Mr. Gullian Chen
+86 132 6058 4523 Mr. Guihua Li
